Jazyk / Language: česky english deutschhrvatskiпо-русскиitalianopolskislovenskymagyar

Toll Rates

Toll Rates Table.

Toll rates since 1.1.2015

Emission class

EURO 0–II

EURO III–IV

EURO V

tarif Euro6

EURO VI, EEV

Number of axles

2

3

4+

2

3

4+

2

3

4+

2

3

4+

Highways and motorways

3,34

5,70

8,24

2,82

4,81

6,97

1,83

3,13

4,52

1,67

2,85

4,12

-- Friday 15-20 h

4,24

8,10

11,76

3,58

6,87

9,94

2,33

4,46

6,46

2,12

4,05

5,88

1st class roads

1,58

2,74

3,92

1,33

2,31

3,31

0,87

1,50

2,15

0,79

1,37

1,96

-- Friday 15-20 h

2,00

3,92

5,60

1,69

3,31

4,74

1,10

2,15

3,07

1,00

1,96

2,80

Busses

1,38

1,15

1,04

0,80

Tolls are not subject to VAT.

Toll rates

Toll rates are stipulated by Czech Government Regulation Nr. 26/2010 Coll. The amount of toll for the use of a particular section of a tolled road depends on the length of the section and the category of the respective vehicle, depending on the number of axles and the emissions class of the vehicle.

Network of tolled selected roads in Czech republic (381) [GIF format (230 KB)]

For approximate calculation of tolls on a specified route may use the toll calculator on this portal.

Toll payment verification

One of the major benefits of the electronic tolling system is that the driver will be immediately aware that a toll transaction has been completed properly and the toll credit charged to the onboard unit is sufficient.

Checking before travelling

The driver is required by law to check all premid unit functions before entering a tolled road. With the brief touch of a button, the onboard unit will signal optically whether or not it functions properly - see the Instructions for the Use of the Premid Onboard Unit (Premid Guide).

Checking while driving

When passing through a toll gate, an acoustic signal from the premid unit alerts the driver that the toll has been properly recorded.. In the event of any discrepancies, the premid onboard unit emits a signal and the driver is obligated to stop at any premid point distribution centre or contact centre to resolve whatever problem there may be. If the driver fails to do so, mobile enforcement units will be notified of the occurrence and the user will be fined.

In the prepaid system, the unit reminds the driver to recharge toll credits.

Checking after the trip

It is strongly recommended that you also check your premid onboard unit’s functionality after using tolled roads to make sure that no discrepancies have occurred. This inspection is recommended to all vehicle operators, especially when changing drivers.

Checking toll payment

Stationary, portable, and mobile devices ensure that tolls are properly collected in the tolled road network. The monitoring system of the electronic tolling system is operational 24 hours a day. It automatically identifies all vehicles that have fail to pay a required toll either fully or partially. In the event of any discrepancies, a mobile enforcement unit is automatically notified right away.

Prosecution of toll cheats, settlement of toll discrepancies

Mobile enforcement is carried out by employees of the General Directorate of Customs of the Czech Republic (Generální Ředitelství cel ČR). They are authorised by law to stop all vehicles identified by the tolling system to investigate discrepancies, and, in the event of legal transgressions, they are also authorised to impose penalties, initiate administrative proceedings, or even impound vehicles that are in violation of the law. In such cases, drivers can expect to face considerable delays and complications. The access to information about transgressions is unlimited time-wise for members of the mobile enforcement units. This means that any vehicle could very well end up being detained for a long time following the discovery of such transgressions.


RSS channel  |  XML Sitemap  |  Sitemap  |  Content Management System WebRedakce - NETservis s.r.o. © 2016